安装完piston后:
1.测量piston表面高度。将表架在#1piston上,设置为0,测量所有piston height,差值不超过10条,最好在5条以内
2测量Z_H:选择piston最高的
1. Select [Maintenance C] – [Custom Maintenance] to enter maintenance mode.
2. Refer to chapter 3.3 “Piston deviation” and measure the height of all the pistons to find the highest piston.
3. Move the highest piston to the front of the machine.
4. Align the pusher with the piston.
5. Set a dial gage to 0 on the piston tip.
6. Lower the Z-axis and use the dial indicator to find the point where the pusher first contacts the piston.
7. Select [Maintenance] – [Proper Data Editor] – [Nozzle Position] – [Z_NzlPosZH] – [Direct Servo Input] to save the current Z-axis counter value to proper data.
8. Select [Input] and add 0.1 mm to the value saved in step 7.
Press CR
Add 0.1 mm
Value saved in step 7
9. Press [CR] to enter the new value as [Z_NzlPosZH].
2,测量Z0
1. Select [Maintenance C] – [Custom Maintenance] to enter maintenance mode.
2. Refer to chapter 3.3 “Piston deviation” and measure the height of all the pistons to find the highest piston.
3. Set the conveyor width to 100 mm.
4. Clamp the plate jig in the main conveyor.
5. Move the head to the front of the machine and install the nozzle jig in the highest piston.
6. Move the nozzle jig above the plate jig.
7. Push the [EMERGENCY STOP] button to cut the 200V power supply to the servos.
8. Align the pusher with the piston.
9. Lower the Z-axis until the nozzle jig contacts the plate jig.
10. Set a dial gage to 0 on the nozzle jig.
11. Raise the Z-axis until the dial indicator just starts to move. This height is Z0.
12. Select [Maintenance] – [Proper Data Editor] – [Machine Origin] – [Z Board Surface] – [Direct Servo Input] to save the current Z-axis counter value to proper data.
4.测量 R axis offset