原帖由1楼楼主 smt_liukai 于2008-09-22 20:20发表 Our speed can up to 10kc/h
你们机器每小时才10K/H？不是吧，飞利浦好像没有这样速度的机器，除非是TOPAZ或者MG1。
smt_liukai
2008-09-23 22:59
sorry,made a mistake! It should be up to 105Kc/h. AX501
smt_liukai
2008-09-23 23:25
The most crucial factor is the feeder setup condition. The speed is quite affected by the program feeder quantity distributing. The more quantity feeder you set in PPSpro program,the lower cycle time it could be reach!
志炜3
2008-09-27 19:04
FCM-I的都能超过来80万点24小时
asmb-ray
2008-10-18 06:07
AX5只要全配TTF全CPR效率是很恐怖的,前提是不能有东西坏,哈哈哈
把苹果咬哭
2008-10-20 21:28
QUOTE:
原帖由7楼楼主 smt_liukai 于2008-09-23 23:25发表 The most crucial factor is the feeder setup condition. The speed is quite affected by the program feeder quantity distributing. The more quantity feeder you set in PPSpro program,the lower cycle time it could be reach!
