Reduce Nozzle Changes (fewer gang picks!): If this option is selected, the optimizer attempts to never change nozzles. It may not be possible to do so, depending on how many nozzles are needed by the product. This option results in fewer gang picks. No Feeder Duplication: By selecting this option, the optimizer does not duplicate feeders in the feeder list on the machine. Leaving this de-selected, the optimizer attempts to duplicate feeders (up to 4 of the same feeders on each side of a dual beam machine) in order to reduce required “pick” movements. If the Change Feeder Type option has been used in the Feeder List to change a component's feeder, the Optimizer duplicates the current feeder. Use Current Feeder Setup: By selecting this option, the optimizer does not move the feeders that are currently mounted on the machine. If additional feeders are required, they will be added to the setup. This includes duplicate feeders. Optimize for Feeder Fit (no gang picks): If this option is selected, the optimizer attempts to save space on the feeder banks by not positioning the feeders for gang-pick or optimal position. Use this option only as a last resort if the feeders do not fit on the banks any other way. Use Machine Nozzles Only: By selecting this option, the optimizer is limited to using the nozzles on the machine in the configuration template. When working online, this option uses what is on the machine. When working offline, choose from the following selections: • Select this option and it uses the configuration template. • Do not select this option and it uses the head setup and nozzle inventory.
rayman
2008-10-30 21:02
文档是稍稍多一点的介绍，UIC文档
rayman
2008-10-31 21:20
GSM开机无法回原点，是XY动作问题还是PEC图像问题： 1。找不到frame fiducial？ －－确认是否有报错“missing a home pulse during .... command”，如果有，最直接的原因是光栅脏，丢失一个零脉冲，查看停止时候PEC相机的位置，确认哪个轴（X1 X2 Y2 Y1）？，然后擦相应的光栅。当然也有可能读数头脏，也擦擦。另外如果PEC没有图象反馈那就不用说了，检查PEC吧。 2。其他X Y轴错误： following ... leading..... 类似错误， －－同样检查光栅，读数头 3、同时注意查看XY amp LED状态，是否报错，以确认是否伺服卡问题。 4、还要注意区分报错是在interlock enable时候还是XY轴开始动作之后。
